I must be missing something.
I have tried to provide access to a webserver inside our network and have set up a NAT rule but can't get access to the server from outside.
If I switch on reflection then I still see nothing but can obviously see it when using the internal 192.x.x.x address
I have done the following
Ensured that the server is responding on the internal IP
Set up a NAT rule as follows
Interface: WAN
Protocol: TCP
Source: Any
Source port Range: FROM: any, TO: any
Destination: Any
Redirect target IP: 192.168.230.x
Redirect Target port: HTTP
Reflection: enabled
Filter rule created to pass and log only.
This should work and I can see the attempted access on the firewall but not sure what to try next. Any suggestions would be greatly appreciated.