Hello everyone, been searching forums here about similar issues I am having, and I cannot seem to find a working solution for my issues. Sorry in advanced if my issue has been posted before. I tried installing the latest version of PfSense (2.3.4) both 64bit and also tried installing the 32 bit edition for giggles. I even tried installing an older version of PfSense I had which was 2.2.6. After each install, when I reboot to the "Welcome to PfSense" screen, I get the following error message, "no filename specified". To give a bit of a background before/during installation, I had to run the following string due to the installer not detecting my drive in Hyper-V: " set hw.ata.disk_enable="1" ". After installation, I tried running the same command and then running "load kernel", but no luck. I am a bit of a PfSense/FreeBSD noob, so...
↧