New PFSense for home, now cannot access QNAP NAS

Hello, I've been trying to figure this one out for days...nay, dare I say a week? I hate saying that, it just shows my lack of resolution on this in my home network. I just installed a PFSense hosted on ProtectLi appliance. Followed the video tutorial from NetworkChuck on setting it up, very basic setup, then followed PIA (personal internet access) for configuring router-based VPN on the appliance. Before this the QNAP NAS was accessible. Now I cannot access it, no ping response or access to it.

In PF Sense it shows that it is getting an internal IP address and the Qnap remote service shows the same LAN IP it is getting, so it has partial internet access at least.

I think the problem is internally only, QNAP is using port 8080 and maybe I have to specifically open that port? I did not install the PFBlocker firewall yet, so it's just...